The firmware added a lot of new options, binding, multi-click, etc. Work on the functionality of the firmware continues, possibly binding, and other options will has written a new open-source firmware. There is a network presence control (if the device is out of the network, pressing the buttons is not confirmed by light and sound). The firmware implements both light and sound indications of pressing. The original firmware was written by Vladislav support in the ioBroker driver was provided by Kirov Ilya for which special thanks to them.Ĭonsumption corresponds to the one declared by the manufacturer, which will allow the remote control to work from one CR2032 element from 1 to 2 years. In comparison with the IKEA TRÅDFRI remote control Held in place by friction.Īnd can be assembled for size estimation, Light transmittance 2%, enough to see the glow of the LED and hide the insides, 3mm thick. The upper part can also be printed, but it is much more aesthetically pleasing to cut out with a laser from plexiglass. For fastening to a metal surface, magnets 9 x 1.5 mm are provided, with an effort they snap into place. While the boards are being manufactured, Jager engaged in the case, Satisfied with the result, Jager place an order for the boards. , but you can also use such as in the picture, it is enough to “bite off” the legs flush with the body. There is a version with contacts for surface mounting. The dimensions of the device are determined by buttons 12x12x7.3 mm with transparent covers, I must say on AliExpress, their choice is very limited and this is practically the only option. There is also a LED and a buzzer on the diagram to indicate both the actual operation of the buttons and the display of service modes. The remote control is powered by one CR2032 element if a 2.5mW module is used, and from two elements via an LDO when using a 100mW module. The advantages of this module are cheapness and ultra-low consumption, 0.4 μA in deep sleep mode. The device is based on a module from EBYTE E18-MS1-PCB or E18-MS1PA1-PCB if an increased communication range is required. This remote control will live in the kitchen, the icons show that it will be possible to control the light, hood, music, set the timer. This can be lighting control, multimedia equipment, various UD scenarios, etc. This is a kind of universal remote control, which displays the most frequently used functions in a particular room.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |